Lithium-ion Rechargeable Battery Pack
This specification describes the type and size, performance, technical characteristics, warning and caution
of the HETER-3.2V100Ah LiFePO rechargeable pack. The specification only applies to HETER -3.2V100Ah
LiFePO pack supplied by HETER ELECTRONICS GROUP CO.,LTD.
2. Product and Model
2.1 Product: Lithium-ion Battery Pack
2.2 Model: 11TR3.6-100-N （26650-3.6V-1S22P）
2.3 Picture And Output Wire （In order to prevail in kind）
3. Battery Pack Specifications
|Typical capacity||100.0±3.0Ah||At 0.2C discharge rate|
|Max continuous discharge||100A|
|Discharge cut-off voltage||About 3V|
Charge mode: CC/CV，Use a constant
current, constant voltage(CC/CV)
please use special lithium charger.
|Inner resistance||≤2.0mΩ||Between positive and negative polar|
When the environment temperature is
higher than 45℃，please pay attention to
ventilation and heat rejection.
Recommended long-term storage
temperature is 15~25℃
4. Standard Test Conditions
Battery test must within 1 month after production.
All test in this specification should be in standard atmospheric conditions: temperature:
25± 5℃, relative humidity: 65±20%.
6. Characteristic curve
7.1Charging current should be less than maximum charge current specified in the Product Specification，
Charging current bigger than recommended current may damage the battery;
7.2Discharging current should be less than maximum discharge current specified in the Product
Specification；Discharging current bigger than recommended current may damage the battery;
7.3 It should be noted that the cell would be possible to be at a over-discharged state by its
self-discharge characteristics in case the cell is not used for long time. In order to prevent
over-discharging, the cell shall be charged periodically to maintain between 3.30V and 3.40V
（2month one cycle），Over-discharging may causes loss of cell performance, characteristics, or
7.4 Please charge the battery within 12 hours after use;
7.5 Battery storage environment follow the above conditions and in standard atmosphere, should be
without strong magnet, no power, no static;
7.6 Do not reverse the polarity of the battery pack for any reason;
7.7 Do not short circuit the battery pack;
7.8 Do not reverse polarity charging;
7.9 Do not immerse the battery pack in water or sea water, or get it wet;
7.10 Do not disassemble battery;
7.11 Do not expose the battery to extreme heat or flame;
7.12 Please use special charger for charging;
8. Product Liability
HETER is not responsible for the incident caused by not obeying the specifications. Before using the
battery, you should read the specifications, usage instruction and some attentions carefully to learn its
application method and areas. If the phenomenon such as error using method or wrong circuit connection,or input power data, working index are inconsistent with the specifications , cause damage to product, load and its accessories, we are not responsible for it.
Our company have the right to change the content of specification without prior notice；
The final explanation of specification belongs to our company.